Machine Design MCQ: The usual proportion for the width of key is (where d = Diameter of shaft or diameter of hole in the hub)

The usual proportion for the width of key is (where d = Diameter of shaft or diameter of hole in the hub)

Correct Answer: d 4

Make the most of this question

This page focuses on one Machine Design question from Engineering. After checking the answer, return to the topic list to practice more or run a timed set.

← More Machine Design MCQs All Engineering topics Mock test hub

WhatsApp+91 99922 70404Machine Design MCQ: The usual proportion for the width of key is (where d = Diameter of shaft or diameter of hole in the hub) | Extra Education