Engineering

Design of Steel Structures MCQs: 315 Questions & Answers in Engineering

315 Design of Steel Structures MCQs in Engineering with answers & explanations. Page 10. Practice objective questions for competitive exams, interviews & sel… Use the answer toggle below to show or hide all solutions, tap an option to check one question, or open a question for its own page.

Page 10 of 16

Show answers

Answers hidden — tap an option or use “View Answer” on each question.

181

Design of Steel Structures MCQs: 315 Questions & Answers in Engineering

An axial loaded column is supported on a slab base whose projection is 8 cm. If the intensity of pressure from concrete is 40 kg/cm2 and allowable bending stress in slab base is 1890 kg/cm2 , the thickness (t) of the slab base, is

The bracing provided in the plane of end posts is called

In a built up beam actual bending compressive stress fbc is given by (when y1 is the distance of the edge of the beam from the neutral axis).

If the thickness of a structural member is small as compared to its length and width, it is classified as

The statical method of plastic analysis satisfies

For the economical design of a combined footing to support two equal column loads, the projections of beams in lower tier are kept such that bending moment under column is equal to

Lug angle is

As compared to field rivets, the shop rivets are

Stiffeners are used in a plate girder

A fillet weld whose axis is parallel to the direction of the applied load, is known as

In a truss girder of a bridge, a diagonal consists of mild steel flat 4001.S.F. and carries a pull of 80 tonnes. If the gross-diameter of the rivet is 26 mm, the number of rivets required in the splice, is

When the bolts are subjected to reversal of stresses, the most suitable type of bolt is

Factor of safety is the ratio of

The best arrangement to provide unified behaviour in built up steel columns is by

The ratio of shearing stress to shearing strain within elastic limit, is known as

In a built up section carrying a tensile force, the flanges of two channels are turned outward

A fillet weld may be termed as

Gantry girders are designed to resist

The distance between e.g. of compression and e.g. of tension flanges of a plate girder, is known as

Design of a riveted joint is based on the assumption:

Study tips for Design of Steel Structures