Engineering

Process Equipment And Plant Design MCQs: 86 Questions & Answers in Engineering

86 Process Equipment And Plant Design MCQs in Engineering with answers & explanations. Page 3. Practice objective questions for competitive exams, interviews… Use the answer toggle below to show or hide all solutions, tap an option to check one question, or open a question for its own page.

Page 3 of 5

Show answers

Answers hidden — tap an option or use “View Answer” on each question.

Process Equipment And Plant Design MCQs: 86 Questions & Answers in Engineering

For identical operating conditions, the pressure drop over _____________ tray is the highest out of the following.

The normal range of velocity of steam in pipes is _______ m/sec.

Rate of filtrate delivery is inversely proportional to the

Holes of a sieve tray are arranged in triangular pitch of __________ times the hole diameter.

In a pressure vessel containing multiple openings of various dimensions at different parts, stress concentration at the edges of the opening is maximum which becomes negligibly small beyond the area covered by __________ times the hole diameter.

Baffle width is normally taken as __________ times the tank diameter.

For storing hazardous chemicals in large storage tanks, the minimum safe distance between the two tanks should range between __________ times the tank diameter.

Baffle spacing is generally __________ the I.D. of the shell.

In a shell and tube heat exchanger, tube side __________ of the mass velocity.

In case of 1.5" heat exchanger tubes, the inside flow area __________ with decrease in BWG.

Overall tray efficiency of a distillation column is the ratio of the number of

Wind load consideration in the design of a support can be neglected, when the vessel is

Vertical condenser is advantageous to the horizontal condenser from operation point of view, when

In a distillation column, bubble caps are located on trays with a pitch of __________ times the outside diameter of the caps.

Minimum tube pitch recommended for shell and tube heat exchangers is about __________ times the outside diameter of the tube.

Brass valves are usually made for pipe sizes __________ inches.

An increase in the liquid resistance to interphase mass transfer and a resultant reduction in plate efficiency is caused by

Welded joint efficiency in the design of chemical process equipment is taken as

Apex angle of conical heads used in the bottom heads of chemical process equipments is usually

A binary liquid azeotropic mixture has boiling point higher than either of the components, when it shows __________ deviation from Raoult's Law.

Study tips for Process Equipment And Plant Design