Engineering

Reinforced Cement Concrete Structures MCQs: 175 Questions & Answers in Engineering

175 Reinforced Cement Concrete Structures MCQs in Engineering with answers & explanations. Practice objective questions for competitive exams, interviews & s… Use the answer toggle below to show or hide all solutions, tap an option to check one question, or open a question for its own page.

Page 1 of 9

Show answers

Answers hidden — tap an option or use “View Answer” on each question.

Reinforced Cement Concrete Structures MCQs: 175 Questions & Answers in Engineering

In a cantilever retaining wall, the bending moment in the vertical stem varies as ?

The cube strength of the concrete used for pre-stressed member should not be less than ?

When a beam is loaded with transverse loads, the bending moment ?

For M 15 grade concrete, the section is to be redesigned if shear stress is more than ?

When the lever arm of a reinforced concrete bream is z and width of beam is b, then the maximum shear stress in a beam subjected to shear force F will be equal to ?

In a combined footing, the reinforcement should be placed ?

For a slab spanning in two directions, the ratio of span to the depth of slab should not exceed ?

The ultimate strength of the steel used for pre-stressing is nearly ?

In a slab, the transverse reinforcement is provided at .............. to the span of the slab ?

A panel of a flat slab is ?

A long column is one whose ratio of effective length to its least lateral dimension exceeds ?

The analysis of slab spanning in one directions is done by assuming it to be a beam of ?

In a reinforced concrete column, the cross-sectional area of steel bar is As, and that of concrete is Ac. The equivalent area of the section in terms of concrete is equal to ?

The effective depth of a singly reinforced rectangular beam is 300 mm. The section is over reinforced and the neutral axis is 120 mm below the top. If the maximum stress attained by concrete is 5 N/mm² and the modular ratio is 18, then the stress developed in the steel will be ?

For M 15 concrete, the unit punching shear strength of concrete is taken as ?

The portion of the slab which acts monolithically with the beam and which resists the compressive stresses, is called ........... of flange of the T-beam ?

According to IS: 456-1978, the spacing of stirrups shall not exceed a distance .......... the lever arm of the resisting moment ?

If L is the lever arm in a reinforced concrete beam, S is the total perimeter of the steel bars and F is the shear force, then the bond stress developed in concrete around the steel reinforcement is ?

The column head of a flat slab ?

In the case of deformed bars, the value of bond stress for various grades of concrete is greater ............... than the plain bars ?

Study tips for Reinforced Cement Concrete Structures